Select Your Vehicle

Pyle 2.0 Farad Digital Power Capacitor Kit

For each


  Pyle 2.0 Farad Digital Power Capacitor Kit

Fits On:

All Jeeps (Universal), All Vehicles (Universal)

2.0 Farad Digital Display Power Capacitor
Capacitance ± 5%, 20-24 Volt Surge, 105o C
Lowest E.S.R. (-0.0016 Ohm)
Chrome Plated Post Kits
Aluminum Brush
Digital Red Display
1 Pair of Clear Brackets Included
DC 12- 24 volt
Electronic Polarity Protection Circuit
Over Voltage Protection Circuit
4 ft. 4 Gauge Power (Clear Platinum)/Grounding (Blue Platinum) Power Wire
Satin Chrome POS-NEG Power Distribution Block
Includes Mounting Charging Hardware
Diameter 3"D x 8.66"H
Pyle made a name for themselves in the 1960s building high-end subwoofers. Their original Pyle Driver speaker was a mainstay in households for several decades. Since then they have expanded their lineup to include a huge range of audio and electronic entertainment products from speakers to DVD players. Based in Brooklyn, NY Pyle has always been proud of its excellent customer service. They also take pride in the fact that they are able to offer high-quality products at very reasonable prices for those who are on a tight budget. Born out of good old American ingenuity, Pyle driver has grown to become a strong presence in the electronic entertainment world.
Q: What does a Power Capacitor do? Why buy a Power Capacitor?
A: A power capacitor is a device used in your car audio setup to act as a buffer between your car battery and amplifier. Wired in line between the battery and amp it works by storing up energy from the battery so that when a drop in system voltage is detected it can temporarily release the stored energy to the amplifier. This helps to stabilize voltage across the system and will extend the life of your car audio components, especially amplifiers. It is important to match your capacitors power capabilities to that of your amplifier.

Q: What does Farad mean when it comes to power capacitors? How do I know which is best for me?
A: A Farad is a means of rating the power of a capacitor. Similar to how wattage is used as the power rating system for amplifiers, farads are used for capacitors. Because a capacitors job is to take some of the load off of the battery when you are running high-powered amplifiers, you will need to match the capacitor to the power output of the amplifier. A good general rule of thumb is that for every 500 - 1000 watts of amplifier you are running you will need roughly 1 farad for the capacitor. So if you are running 3000 watts of amplification you will need a 3+ farad capacitor.

See all 3 questions & answers
Exhaust Systems
Exhaust Systems
Cold Air Intakes
Projector Headlights
Euro Tail Lights
Body Kits
Racing Seats
Audio Sitemap